All about Plumbing Tricks

Installing  malleable iron pipe  fittings is as simple as attaching the regular couplings used with galvanized pipe. Ensure you have the correct sized tools to tighten and seal the malleable iron pipe fittings to each other or to galvanized pipe. Step 1: Choose the Correct Size and Function Choose from 90-degree elbow fittings, 45-degree fittings, T-junction fittings or a wide range of other malleable iron pipe fittings for the task. Ensure the diameter of the fitting matches the pipe sections it will connect. Step 2: Cut the Pipe Section as Needed Use the metal hacksaw to cut through copper or other pipe to install elbows and T-junction fittings. Always wear safety goggles for eye protection when sawing through metal. Step 3: Clean the Pipe Junction Wipe the pipe junction where you will install the malleable iron pipe fitting with a clean, dry rag to remove any corrosion, dust, or metal filings left after sawing through the pipe. Sand the end of the pipe to ...

plumbing snake  is a handy tool to have around the home. When the toilet, or other drain, becomes clogged with waste the plumbing snake can drill through it and break the clog up to get the water flowing again. This plumbing necessity is a very easy to tool to use. A homeowner can successfully use a plumbing snake to work their way through most clogs without any problems. How Snake Works A plumbing snake is basically a small auger that is attached to a long flexible metal wire. In order to use the snake in a drain you feed the metal wire into the drain until it reaches the obstruction. Once it hits the clog the operator then turns the handle on the snake in order to turn it like a drill. This works its way through the clog and breaks it up. Working the snake is easy, but there are some things to keep in mind. Prepare Area First Using a snake can be a little messy if the toilet is backed up with water. Make sure to lay down several towels or rags around the toilet to cat...

An outdoor kitchen is a great addition to the patio. Not only does it provide you will plenty of storage options, but you also have the luxury of an outdoor sink for washing up. Here are a few simple steps to help you properly plumb an outdoor kitchen in no time. Step 1 - Linking to Main Water Pipes To get started, you need to run supply pipe from inside the house that is rated for outdoor use. The pipes should be held in place with two-hole clamps and you don’t need to insulate the pipe unless you are running hot water. The pipes should be sloped to help drainage and can be buried underground for a more aesthetically pleasing look. You should also install shut off valves and drain plugs at the low points of the piping. Step 2 - Running the Pipe Outside With the supply piping in place, run it through the wall and towards the outdoor kitchen. The pipe should come up through the bottom of the cabinet. You may need to use thread adapters to connect the pipes to the plumbing ...